SPONSOR

Featured

Floating head versus U tube heat exchanger








Floating head versus U tube heat exchanger











Floating head heat exchanger

  1. Split back ring type
  2. Pull through bundle type
  3. Outside packed Lantern ring type
  4. Outside packed stuffing box type




Split back ring type unit is more commonly used in industries. In this type of construction straight tubes are fixed at both ends in stationary and floating tube sheets. The floating head is fitted to the tube sheet which is away from the channel. The floating head is held in position by a split backing ring so that dismantling is possible. The floating tube sheet diameter is kept slightly smaller than the inner shell diameter so that the entire tube bundle can be removed from the channel end. The shell is closed by a bonnet on the floating head side.




The advantages are that the tube bundle can be removed for inspection and cleaning. Tubes can be replaced if damaged. Any number of tube side passes can be employed.
In this unit gasket, joints are very large, therefore it is costly. It is used below 70 kg/cm- pressures. Above these pressures floating head gasket may start leaking. Floating head heat exchangers are suitable for heavy duties associated with high temperature and pressure and large temperature differences. Fouling fluids can be handled because the cleaning of tubes from inside and outside is possible. These units are widely used in petrochemical plants and chemical industries.

Advantages

  • The tube bundle can be removed for inspection.
  • Mechanical cleaning of the outer surface of tubes is easily possible.
  • Since tubes are straight, individual tubes can be replaced. Inside tube surface can be
  • cleaned without removing the tube bundle.
  • No limitation on a number of tube side passes.




Disadvantages

  • It is very costly.
  • It has a large number of gasket joints.







U tube heat exchanger






 The tube bundle consists of U shaped tubes. Both ends of U tube are fixed in the same tube sheet. Thermal expansion resulting due to the temperature difference between shell and tube material is taken care off by U bends. U tubes can expand or contract freely and uniformly. It performs the same function as a floating head. It also reduces the number of joints

Advantages

  • Initial cost is low.
  • Internal gasket is eliminated.
  • Only one tube sheet is required.
  • Tube bundle can be removed for cleaning and inspection.
  • Bypassing of shell-side fluid is minimum due to minimum clearance between the shell and outermost tubes,
  • It is easy to clean channel, tube side headers. Gaskets can be easily replaced.




Disadvantages

  • Tube inner surface can be cleaned by chemical means only.
  • .Individual tube replacement is difficult.
  • Less number of tubes can be fixed on tube sheet because of U bends.
  • Tube side passes can not be increased or decreased.
  • Tube side velocity can initiate corrosion on the inside of bends.









No comments